Search:

Type: Posts; User: jakebryan8

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    170

    Pressure output?

    Is there a way to determine how much pressure I will be putting out if building a washer? I am putting a tsf2021 from General Pump (8.5 gpm) on a 13 hp motor at 1450 rpms.
  2. Replies
    4
    Views
    1,046

    Very true. Hopefully at the least I can get the...

    Very true. Hopefully at the least I can get the bid for the roof.
  3. Replies
    4
    Views
    1,046

    Thanks Ken. May pass this one by. Not worth all...

    Thanks Ken. May pass this one by. Not worth all the headache.
  4. Replies
    4
    Views
    1,046

    Dryvit house wash

    Hoping you guys can give me some direction on this house wash. I have a job to send a bid out on, first time dealing with Dryvit. Iíve done some research on here, but the question is will a strong SH...
  5. Replies
    3
    Views
    1,048

    Sorry for the late response, but it was the check...

    Sorry for the late response, but it was the check valves. I pulled them all out and found one that had a small pebble stuck in it. I have no idea how that managed to get through. The unit has a 5...
  6. Replies
    3
    Views
    1,048

    Pressure going in and out??

    I am having an issue with my unit losing and gaining pressure. Not completely, but it loses pressure slightly then picks it back up again. Does anybody have any ideas as to what could be causing the...
  7. Replies
    4
    Views
    1,082

    Thanks for the advice guys! Mike- nice to see a...

    Thanks for the advice guys!
    Mike- nice to see a fellow Marylander here. (Glad to see you're on the Western Shore rather than Eastern Shore for sake of competition lol)
  8. Replies
    4
    Views
    1,082

    Pump for direct application

    I am still somewhat of a novice, so I am looking for some help. I prefer direct application rather than downstreaming when washing siding. Looking to buy one of bob's diaphragm pumps, but not sure...
  9. Replies
    0
    Views
    539

    12.5 in Maryland?

    Im kind of new here, I was hoping someone could point me in the direction of a good SH supplier in Maryland? The closest one I have been dealing with is in Baltimore which is getting to be a bit of a...
Results 1 to 9 of 9